Lang

Industry News

GREEN TELECOM TECHNOLOGY CO.,LTD
Located in Ningbo,China.

Home / News & Events / Industry News / Greentel Fiber Patch Panel Systems must be Easy to Use

Greentel Fiber Patch Panel Systems must be Easy to Use

Greentelftth Fiber Patch Panel consists of an array of duplex SC adapters, hybrid adapters, or Small Form Factor (SFF) jacks. If the entire installation, including the fiber optic hubs, repeaters, or network adapters, uses the same type of fiber optic connectors, then the array can be made of compatible adapters or jacks. Fiber patch panels are mostly mounted in 19 inch relay racks, but they can also be mounted on freestanding rails, in cabinets and also on walls. For fiber optic cabling installation, you should plan the location of your fiber connectivity hardware carefully, including fiber patch panels. You can choose between direct cross-connection and patch panel. It is also necessary to arrange your routing and dressing of your fiber patch cords if you choose to use fiber panels. In the meantime, you also have a choice to use fiber cable management brackets to avoid the dangling fiber patch cables. When surmounting trouble rises, an optic fiber technician must choose the most suitable patch panel for a particular situation. That technician must recognize that when it comes to easy installation, proper termination and long term maintenance, not all patch panels are created equally. The fiber is solid and therefore worth some special treatment. For example: if a horizontal copper cable is damaged, one user will be affected. If a backbone fiber goes down, it can take a lot of users down with it. This is why using fully enclosed connecting hardware for optic fiber is crucial. This is where the technician must choose between using wall-mounted or rack-mounted hardware. The optic fiber density required will most likely influence the technicians choice between the wall-mounted and rack-mounted connectivity. Many technicians will choose to use fiber patch cables. Since the copper wiring board needs to be strong enough, it will not bend too much because the cable is stamping. The rolled edges on the panel sheet metal stock help to make the panels rigid. Copper patch panels should provide 24 ports in a 1U height or 48 ports in a 2U height. It's very important to make sure that the modular jacks and circuit traces on the panels are protected from debris that can short out circuits. All cable management systems must be easy to use and maintain to avoid any potential problems.

Recommended Products